Get The Perfect Dartboard And Install It Properly

Dartboards are typically made of sisal fiber and a slimcomfortable with. While others prefer the classic
metal wire lines every section. The numbers showingblackboard and chalk, you may not, as it does create
the scoring sections in the board is usually made ofchalk dust that gets on to your hands and fingers, and
wire. The dartboard is divided into twenty sections,you might also be allergic to chalk particles. If you are,
each with a scoring of one to twenty points, by wiresthere are many alternatives.
that extend from the small inner circle to the outer3. Scoring:
circular wire.Traditionally, sections of the dartboard is numbered and
1. Hanging Procedure:colored black and yellow. By hitting one of the large
A dartboard should be hung in such a manner that thenumbered sections, you score according to the value
distance, using the center of the bullseye as a point ofof that section. By hitting the thin outer portion of the
reference, is five feet and eight inches parallel to theboard which are red and green, you score a double
hockey line. Hang the dartboard on a backing, such aspoint, whatever the value of that certain section.
a backboard or any type, such as plywood, to preventLikewise, when you hit the thin inner portion of these
occasional wild darts from ruining your wall. Ideally, thesections, halfway between the central circle, colored
backing is twice the size of the board and you couldred or green and the outer wire, your score is triple the
cover it with either felt paper or cloth so that it lookspoints of whatever value that is imbedded in that
neat. Make sure too, that the backing is secured firmlysection. Hitting the bullseye or the inner red area
to the wall and should not sway or vibrate, when hit byscores fifty points and hitting the green outer ring
darts. The hockey, or the line measurement has to bescores twenty five points. There is no score when you
7 feet 9.25 inches from the board's face horizontally tohit outside the outer wire. Any dart that is thrown on
the floor. To obtain a precise measurement, start fromthe board but does not remain on the board, such as a
the line from the bullseye going down to the floor,bouncing dart or a dart that fell after it has been
measuring 9 feet 7 3/8 inches.thrown, scores nothing. Some rules, however, allow
2. Lightingscoring if a dart hits an obvious scoring section and
Install some lighting. Shadows can be created due tothen drops and is caught before it reaches the ground
poor lighting. Put up a bright light, making sure that it isor floor.
concentrated and aimed to the board. Place a cover4. Dartboard Types:
to keep off incoming darts as well as to hold back theTraditional bristled dartboard
light, away from the thrower's eyes. Your lightingBristles has the function of holding on to the darts so
should be set up in a way that it radiates to the entirethat it cud not fall easily to the surface and puncture it.
area of the board, not causing any shadow and notIt naturally heals itself if cleaned and dust is removed.
interrupting your throw. The location of the scoreboardMagnetic dartboard
should be on either side of the board and not toA dart with no needle, it uses high energy magnets in
interfere with the next player's shot when one ismaking the darts stick to the board. This board is
scoring. The scoreboard's size will be up to you. If youmade from rubberized iron to attract magnet. This is a
plan on having a lot of people over, a wide scoreboardgreat practice game for kids. Very safe and attractive,
may be the best choice so you can write challengesas cartoon characters are displayed on the face of
aside from the score. There are many kinds ofthe board.
scoreboard available, so choose the one that you are